How To Start Screws Into A Metal Roof Panel

Beginning at the outside edge of your roof place each panel directly onto the purlins that are attached to the roof trusses.

How to start screws into a metal roof panel.

Take your first sheet of metal and place it on the roof so that it overhangs the edge at least 3 4 in 1 9 cm. The advantage to this method is the screws are exposed to less water and debris. Therefore you do not need to pre drill the holes. Installing the metal roofing screw in the high of the corrugated roofing panel as shown below.

Try to space the screws about 12 inches apart down the entire piece of metal. Preventing leaks lengthens a roof s life. Add the metal panels. And for any exposed fasteners try to avoid over tightening them.

Proper metal roofing installation begins with the use of the right equipment starting with the screws used to anchor your panels or shingles to the structure. You will use metal roofing screws to secure the metal panels to the sheathing. Many newer metal roofs are built with exposed fasteners which can leak if the metal roof installation guide is not carefully followed. Place the cover over the vent opening and screw into place.

To install corrugated roofing start by cutting your panels to length with an angle grinder. Align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof line. Take care the first piece is aligned precisely perpendicular square to the edge. A metal roof is a long lasting roof but checking the screws for damages is an important part of metal roof maintenance.

Absolute steel recommends using metal self tapping screws with thin washers that have been properly compressed to ensure a secure seal. In addition if the metal roofing panel is being installed over metal purlins the spacing of the purlins might make it tricky to pre drill the sheeting in advance. This means that the screw will drill its own hole through the metal roofing panel and into the metal or wood substrate. Start from the top of the roof and remove the old shingles along with the flashing underlayment and vents.

Next pre drill holes on the end and side ridges of the panels spacing the holes 6 to 8 inches apart.