If not installed properly this will impact the effectiveness of your whole gutter systems.
How to tie gutter into drip edge.
When there is a gap between the gutter and drip edge where water can splash up against the fascia board and run behind the gutter this extension drip is installed behind the drip edge to make water flow into the gutter.
Drip edge is an essential part of the roof system.
7 drill 3 16 inch holes into the gutter s front edge using the holes in the brackets as a guide.
Tools supplies tin sn.
A drip edge or a gutter apron keeps your roof secure by filtering out all the water from the attic into the gutter.
Flashing used to extend drip edge past the fascia.
Its purpose is to direct water away from your fascia and rake boards and into your gutters where applicable.
This will prevent water from coming down behind the gutter.
Most premade drip edge flashin.
The whole purpose is to direct the water into the gutters.
For proper water drainage the drip edge on the rakes should always overlap the drip edge on the eaves.
It should extend from the roof decking down into your gutters.
With without rain gutters.
If there s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge get some roll flashing and tuck it up under the drip edge and over the top of the gutter.
Home centers sell rolls of 6 in.
The drip edge further diverts it into the gutter.
This works out.
It should never be installed outside the gutter i e against the fascia board.
This is important to protect damage to your fascia soffits rafters.
If you are installing a roof system drip edges and gutter aprons play the main role.
Drip edge is an l shaped piece of metal that is installed at the edge eave of your roof.
Once the apron s in place fasten it with sheet metal screws.
We can also relate it to gutter systems.
The best practice is to always install the drip edge so that it is inside the gutter.
Its main purpose is to eliminate the water from going behind the gutter.
When it rains the water from the roof goes to the edge of the shingles and when the water backflows it hits the drip edge.
