Install the flashing place the flashing between the joint of the house and the roof.
Install flashing on porch roof.
Ensure it sits flat and extends at least 8 inches above the shingles.
Bend it back so that it overlaps the corner flashing.
Typically flashing is installed using roofing nails and roofing cement.
Step flashing for chimneys.
Now notch the first step flashing so that it.
Prepare the area where you will install the roof flashing.
In order to properly install new flashing you ll have to remove the shingles surrounding your old flashing and then re lay them after installation.
Hammer one nail to the.
Flashing is generally installed at any joints or edges in the roof where water could otherwise work its way in.
How to install step flashing with a wall corner step three.
Nail the flashing securely in place using roofing nails.
Lay the cut flashing down at the corner.
The flashing on the wall should be flush against it and the porch roof portion should be on top of the shingles.
Then set the piece down.
Flash the corner first if applicable.
How to flash a porch addition 1.
How to install porch roof flashing step 1.
If you already have faulty flashing installed you.
Measure the length of the porch roof joint to determine how much flashing you will need.
Put on a pair of leather palm gloves to avoid injuries from the sharp edges of the metal flashing.
Cut an angle with tin snips on one side of the flashing piece from an end.
